Richter stand-offs adjustable

,,Richter "stand offs adjustable With this engine mounting system every modeler is able to adapt to internal combustion engines of 30-200 cc individually to his model. Without access to metalworking machines to own.

Through this system it is possible to easily adjust the distance of the cowl to continuously spinner back. Also, the setting of motor train at the airport without any problems. Simply open cowl, loosen the motor mount, adjust bolt to the desired extent, tighten, assemble, fly further. After finished adjustments should be applied at the transition between the flange and threaded bolts a few drops of thread lock. Thus, the bolt can not rotate together, but a screw apart is still possible.

The standoffs are designed so that all dimensions of the head frame can be infinitely bridge from 20mm to 60mm to the trailing edge motor flange. This is achieved in that the bolts are fitted with a continuous thread of M16x1. The thread is in intervals by an undercut of 1.5mm designed the on the undercut each modeller can simply cut the part to the desired length with a hacksaw. It should be noted that the threaded approaches are not damaged. Even the waste piece should be clamped in a vice when cutting so that the thread is not damaged by the payload. Note, further, that the thread must be screwed at least until the next groove in the flange in order to achieve a high strength. Furthermore, the end face of the bolt is rotated at a spherical end face. In this a small disk with a spherical surface is inserted, thereby resulting wedge-shaped openings are continuously bypassed in all directions up to about 4 ° with variable settings from the sidecut and camber engine. The holes in these pieces are designed for M5 screws. However, it is easily possible to drill out the parts for M6 screws. It is important that at larger pitch angles the screws are not tightened in the motor mounting plate.

Features:

• Suitable for single-cylinder boxer engines and 30-200 cc
• Weight: about 130g