Spray paint black 9005

content: 400g

Application areas: Suitable for wood, metal, paper, glass, GRP, foil, plastic (lexan), EPO, EPP, Elapor

Quality: High quality synthetic resin varnish

Properties:

• Quick-drying
• high covering and filling power
• durable board and gloss resistant
• scratch, shock and impact resistant
• perfect adhesion
• resistant to synthetic oils
• heat resistant up to approx. 75°C

Times: All time specifications are based on room temperature (= +20°C to 22°C). Depending on the thickness of the applied paint layer, the drying times may differ from the times indicated. In case of doubt, allow the paint to dry longer!

Application: Surface preparation: Application the substrate must be clean, dry and free of grease (wash lexan with acetone) Sand and prime with filler. Leave to dry for 1-2 hours.

Painting in general: Bring can to room temperature. Shake vigorously before use and spray on a test basis. Spray several thin layers at intervals of approx. 2 minutes. Spray distance approx. 25 cm.

Painting one colour: Several layers of the same colour can be sprayed on top of each other within 2 hours. Do not overpaint between 2 hours and 24 hours.

Painting several colours on top of each other: Basically the paint to be painted over must be dry. Waiting time between first and second paint: approx. 24 hours.

Attention: Do not spray on acrylic paint and do not spray with acrylic paint

drying:

• dust-dry after approx. 30 min
• adhesive-free after approx. 3 hours
• Dried out after approx. 24 hours

spend: 400 ml are sufficient for approx. 1 m² depending on colour and hiding power

Recommendation: Spray only in dry weather and in places sheltered from the wind and in well-ventilated rooms. Temperatures preferably between +15°C and +25°C

Disposal: Only put the completely empty can into the recycling container. Take the paint can which has not been sprayed empty to the problem waste disposal point.

Tip: When varnishing small areas, we recommend using a cardboard as a stencil in which a hole is cut, slightly larger than the area to be varnished. The cardboard is held about 1-2 cm above the spot. With this method a substantial part of the spray mist is caught.

important: This application-technical information is given to the best of our knowledge. However, it is only non-binding information and does not release the user from his own tests regarding the suitability for the intended applications. Application and processing are beyond our control and are therefore the sole responsibility of the user.